FORM NO, 3316-954 MODEL NOS.
CONTENTS Page MODEL AND SERIAL NUMBER ASSEMBLY ATTACH HEAR DISCHARGE MOWER ATTACH DISCHARGE CHUTE SIDE DISCHARGE MOWER INSTALLATION ATTACH MOWER TO TRACTOR INSTALL FRONT PULLEY SUPPORT INSTALL DRIVE BELT AND COVER. CHECKING MOWER LEVEL MOWER LEVEL TRACTOR LIFT BAR TRUNCATION AND LIFT ROD ADJUSTMENT Page TRANSPORT LEVEL STOP ADJUSTMENT ..
MODEL AND SERIAL NUMBER A Odets and Serial Number identifies your Toto Wheel Horse attachments, These numbers should pkwy b red 1o when consulting with your dealer oy factory concerning service, replacement parts, or guest ions you may have. For your reference, record numbers from Model and Serial Number plate on your attachment, MODEL SERIAL NO. Height control lever must be attached fo Mower, as described below. Raise rear of mower and support deck on both sides, using wood block.
Turn front wheels of tractor fully left. Raise tractor attachment life, Side mower under tractor until mower center leveler bar is directly under right side of tractor frame. ATTACH MOWER TO TRACTOR Lower factor attachment Niff. Remove washer and hairpin cotter installed on tractor lift bar pin (Fig. 7). Align Sift bar and plo (attached to Tractor) with soot in mower leveler bar (Figs. 3 & 4). FiG. 4 Align Pin with Riot Push maser in until it is centered under tractor.
F SUPPOSITORY WL NOT LOG INTO ETCH, TURN KNOB CLOCKWISE Bt FiG. 8 Install Pulley Support INSTALL DRIVE BELT AND COVER Turn belt tension adjustment knob all the way clockwise (Fig. 9). install drive belt in groove of mower drive pulley and position bet strands around idler pulleys, with inside strand in "V pulley and outside strand making a back bend around flat idler (Fig. 10). Place drive belt on inside groove of PTO pulley as described in tractor Operator's Manual (Fig. 11). . FiG. 1.
Fi. 14 Level Adjustment Nut Under some unusual mowing conditions, mower may leave & "streakā of uncut grass, which can be caused by any of the following conditions? 1. Engine being operated at less than full thrower, 2. Dull blades or underside of mower deck clogged with dalmatian grass. 3. Ground speed too high for conditions-adjust to 2 mph (3.2 kph), or less if necessary. 4. Streaking on turns indicates turns are being made o sharply. 5.
TRANSPORT LEVEL STOP ADJUSTMENT For normal operation mower level stops should be adjusted so that carriage bolt heads are set at bottom of bracket sits. i mower Is not level, in fully raised position, level stops may be adjusted by moving them in bracket slots as required (Fig. 15, 16 or 17). REMOVAL Set mower gags wheels in lowest cutting position and lower mower with tractor it Turn front wheels all the way left. Turin drive belt tension adjustment knob clockwise all the way and removal blat from mower.
To obtain optimum mowing results, mower blades should be kept sharp and well balanced. To sharpen blades, remove mower from tractor and invert mower. Remove blades using optional Toto Wheel Horse spindle blade wrench. Refer to Parts Manual for part Number. Hold spindle hex with wrench while removing blade attaching nuts and washers from end of spindles.
Consumer Products THE TOR TOTAL COVERAGE GUARANTEE A Full Two-Year Warranty {Limited Warranty for Commercial Use) What Is Covered By This Express Warranty? The Toto Company promises fo repair any TOR Product used for residential purposes if defective in materials o workmanship for a period of twa years from the date of purchase The cost of parts and labor are included, but the customer pays the transportation costs, Transportation within a 15 mile radius of the servicing dealer is covered under this warrant