Service Manual

5-28
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
CHASSIS
Park Brake Handle Assembly
Installation
1. Connect the upper brake linkage to the brake shaft.
2. With the park brake handle hardware orientated as shown, install the bolt and ange nut (Figure 31).
3. With the park brake shaft in disengaged position and the park brake lever in the lower position, rotate the upper
brake linkage until the end aligns with the hole in the park brake lever (Figure 32).
4. Secure with a locking cotter pin (Figure 31).
5. Cycle the park brake lever to ensure that it locks in the engaged position.
6. Connect the battery terminals and verify proper function.
Figure 32
Figure 31
A
B
C
A
B
C
A. Locking Cotter Pin
B. Bolt
C. Flange Nut