Service Manual

5-29

Digital Edition - TITAN® HD Service Manual

January 2018

Table of Contents

CHASSIS

Chassis

Adjusting the Park Brake

Service Interval: Every 500 hours

NOTE: Check to make sure the park brake is adjusted properly. This procedure must be followed after the

rst 100 hours of operation and every 500 hours thereafter; or when a brake component has been

removed or replaced.

1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,

and remove the key. Engage the parking brake.

2. Raise and support the unit so that the drive wheels are off the ground.

3. Release the drive wheel bypass valves so that the drive wheels are able to spin freely.

4. Engage and disengage the brake and check each drive tire to make sure that the brake engages and

disengages.

5. If adjustment is necessary, disengage the park brake. Remove the locking cotter pin from the upper brake

linkage (Figure 34).

Figure 33

Figure 34

A. Cotter Pin

B. Park Brake Handle

C. Brake Linkage Shaft