Service Manual

5-37

Digital Edition - TITAN® HD Service Manual

January 2018

Table of Contents

CHASSIS

Chassis

Adjusting the Motion Control Handle Position

NOTE: Ensure proper adjustment of neutral and tracking settings before adjusting the motion control

handles see “Neutral Adjustment,” chapter 7, page 7-4 and/or “Tracking Adjustment,” chapter 7,

page 7-7.

1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,

and remove the key.

2. Move the levers into the operating position.

3. Loosen the two bolts (A) that secure the motion control handles to the motion control assembly (Figure 43).

4. Align the levers front to back and secure the bolts.

5. Move the levers into the park position.

6. Verify proper function of the unit.

NOTE: Motion control levers may be adjusted up or down for operator comfort by utilizing the additional

mounting holes on the motion control assembly. The motion control levers should always be

mounted on the inside of the motion control assembly (Figure 42).

Figure 43