Service Manual
6-6
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
ENGINE
Toro Twin Cylinder Engine
Removal (Cont.)
16. Remove the engine mounting bolts.
NOTE: Before removing the engine mounting bolts, note the orientation of the clutch anchor. The clutch
wire can remain attached to the clutch anchor.
17. Lift the engine away from the frame.
Installation
1. Prepare the frame and secure any fuel lines or wire harness components.
2. Install the mufer and new exhaust gaskets.
3. Torque the mufer mounting bolts or nuts to 20 ± 2 ft-lbs. (25-30 Nm).
4. Carefully lower the engine onto the frame.
5. Align the four holes of the engine base to the frame and attach the two rear mounting bolts and two belleville
washers loosely (orientation shown Figure 7).
6. Attach the front two bolts and two belleville washers through the clutch anchor and into the engine base.
7. Torque the four engine mounting bolts to 30 ± 3 ft-lbs. (36-45 Nm).
8. Install the key and engine pulley onto the crankshaft.
NOTE: Install the engine pulley with smaller diameter hub toward the engine.
Figure 7