Service Manual

6-14
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
ENGINE
Kohler Engine
Installation
1. Prepare the frame and secure any fuel lines or wire harness components.
2. Install the oil drain hose assembly (A) (Figure 19).
NOTE: Apply pipe sealant to the threads at installation. Torque to 20 ± 3 ft-lbs. (23-31 Nm).
3. Carefully lower the engine onto the frame.
4. Align the four holes of the engine base to the frame and attach the two rear mounting bolts and two belleville
washers loosely (orientation of the washers shown Figure 20).
5. Attach the front two bolts and two belleville washers through the clutch anchor and into the engine base.
A
B
C
D
Figure 19
Figure 20
A