Service Manual
6-22
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
ENGINE
Kawasaki Engine
Installation
1. Prepare the frame and secure any fuel lines or wire harness components.
2. Install the mufer and new exhaust gaskets.
NOTE: Torque the mufer mounting bolts or nuts to 13 ft-lbs. (16-19 Nm).
3. Install the oil drain hose assembly (A) (Figure 31).
NOTE: Torque oil drain hose (at engine block) to 26 ± 3 ft-lbs. (31-40 Nm).
4. Carefully lower the engine onto the frame.
5. Align the four holes of the engine base to the frame and attach the two rear mounting bolts and two belleville
washers loosely (orientation of the washers shown in Figure 32).
6. Attach the front two bolts and two belleville washers through the clutch anchor and into the engine back.
A
C
B
D
Figure 31
Figure 32
A