Service Manual

6-23
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
ENGINE
Engine
Kawasaki Engine
Installation (Cont.)
7. Torque the four engine mounting bolts to 30 ± 3 ft-lbs. (36-45 Nm).
8. Install the key and engine pulley onto the crankshaft.
NOTE: Install the engine pulley with smaller diameter hub toward the engine.
9. Install the clutch onto the crankshaft ensuring that the slot in the clutch aligns with the tab on the clutch anchor.
10. Install the two spring washers and the clutch bolt (Figure 33).
11. Torque the clutch bolt to 55 ± 6 ft-lbs. (66-83 Nm).
12. Install the hydrostatic drive belt see “Hydrostatic Drive Belt Installation,” chapter 7, page 7-11.
13. Install the mower belt see “Mower Belt Replacement,” chapter 8, page 8-5.
14. Connect the clutch wire to the clutch.
15. Connect the choke cable see “Choke Cable Installation,” chapter 5, page 5-26.
16. Connect the throttle cable see “Throttle Cable Installation,” chapter 5, page 5-24.
Figure 33