Service Manual

7-19
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
HYDROSTATIC DRIVE SYSTEM
Drive
Hydrostatic Drive Transmission
Installation (Cont.)
12. Carefully install the drive belt see “Drive Belt Installation,” chapter 7, page 7-11.
13. Install the mower belt, see “Mower Belt Replacement,” chapter 8, page 8-5.
14. Verify that the hub nut is properly torqued, torque to 250 ± 10 ft-lbs. (325-353 Nm).
15. Install the drive wheel and torque the lug nuts, torque to 95 ± 5 ft-lbs. (122-135 Nm).
16. Add hydraulic oil to the reservoir to the FULL COLD line.
17. Connect the battery terminals and verify proper function.
18. Follow the purging procedure to remove all air from the system see “Purging Procedure,” chapter 7, page
7-8.
NOTE: Check level of the hydraulic uid and add if necessary.
19. Adjust the neutral setting if necessary see “Neutral Adjustment,” chapter 7, page 7-4.
20. Lower the unit and verify proper function.
21. Adjust the tracking if necessary see “Tracking Adjustment,” chapter 7, page 7-7.