Service Manual

8-11
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
MOWER DECK
Deck
Mower Deck
Removal
1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,
and remove the key. Engage the parking brake.
2. Disconnect the battery terminals.
3. Remove the height adjustment pin and lower the deck to the ground.
4. Place the height adjustment pin in the 3 in. (76 mm) height-of-cut position.
5. Remove the mower belt covers.
6. Remove the mower belt, see “Mower Belt Replacement,” chapter 8, page 8-5.
7. Remove the two bolts and nuts from the front of the plate under the footrest (Figure 10).
8. For 60 in. Decks only:
- Raise the deck to the transport position.
- Slowly loosen the adjusting screw on the lift assist spring until the screw can be removed. Save the screw for
re-installation.
A
A
B
Figure 10
A. Remove the Nuts and Bolts here
B. Remove the Nuts and Bolts here