Service Manual

8-18
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
MOWER DECK
Mower Spindle
Assembly
1. Inspect the inside of the spindle housing for wear or damage.
2. Press the top bearing into the spindle housing by pressing equally on the inner and outer race.
NOTE: Ensure that the bearing seats against the shoulder in the spindle housing.
3. Flip the spindle housing over and install the bearing spacer.
4. Press the lower bearing into the spindle housing by pressing equally on the inner and outer race.
NOTE: The inner and outer race on the upper bearing must be supported while installing the lower
bearing.
5. Apply grease to the spindle shaft and install the spindle shaft.
NOTE: Brush grease completely around the outer seal of the bearing before installing the spindle shaft.
6. Flip the spindle over while supporting the shaft through the spindle housing.
7. Install the bearing shield.
NOTE: Brush grease completely around the outer seal of the bearing before installing the bearing seal.
9. Install the pulley.
10. Install the washer and nut. Torque the top nut to 105 ± 5 ft-lbs. (136-149 Nm).