Service Manual

8-22
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
MOWER DECK
Leveling the Mower Deck (Cont.)
12. Carefully rotate the blades side-to-side so that they are parallel to the rear of the deck.
13. Loosen the leveling adjustment lock nuts (Figure 18) on all four corners so that the deck is sitting squarely on
all four blocks.
14. Remove any slack from the deck hangers and make sure the deck lift foot lever is pushed back against the
stop.
15. Tighten the four leveling adjustment lock nuts.
16. Ensure that the blocks t snugly under the deck skirt and that all attachment bolts are tight.
17. Continue leveling the deck by checking the front to rear blade slope.
18. Recheck the level of the blades and repeat deck leveling procedure if necessary.
19. For 60 in. Decks only:
- Raise the deck to the transport position.
- Reinstall the lift assist spring adjusting screw (removed in step 7 above).
- Set the gap between the spring and the bracket to 7/8 - 1-1/8 in. (22-29 mm).
Servicing the Cutting Blades
See “Servicing the Cutting Blades,” chapter 3, page 3-45.
A
B
C
D
Figure 18
A. Leveling Adjustment Lock Nuts
B. Deck Lift Arm
C. Deck Hanger
D. Chain