Service Manual

9-6
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
ELECTRICAL
Key/Ignition Switch (Cont.)
Testing
1. Remove the control panel from the right console.
2. Disconnect the ignition switch from the wire harness.
3. Using a digital multi-meter set to the OHM or Continuity setting, verify that continuity exists between the
terminals listed for each switch position.
4. Using a digital multi-meter set to the OHM or Continuity setting, verify that NO continuity exists between the
terminals not listed for each switch position.
Position Circuit “Make”
1. OFF None
2. Run B + R + I + A
3. Start B + R + I + S