Service Manual
3-42
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
MAINTENANCE
Hydraulic System Maintenance (Cont.)
Removing the Hydraulic System Filters (Cont.)
5. Carefully, clean the area around the lters.
NOTE: Do not allow dirt to enter the hydraulic system - contamination may occur.
6. Place a drain pan below the lter to catch the oil that drains when the lter and vent plugs are removed.
7. Locate and remove the vent plug on each transmission.
8. Unscrew the lter to remove it and allow the oil to drain from the drive system.
9. Repeat this procedure for both lters.
Installing the Hydraulic System Filters and Adding Oil
1. Apply a thin coat of oil on the surface of the rubber seal of each lter.
2. Turn the lter clockwise until the rubber seal contacts the lter adapter, then tighten the lter an additional ¾ to
1 full turn (Figure 32).
3. Repeat for the opposite lter.
4. Install the lter guards over each lter that you previously removed.
5. Use the three screws to secure the lter guards.
B
A
C D
E
F
3/4
Figure 32
B