Service Manual
3-43
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
MAINTENANCE
Maintenance
Hydraulic System Maintenance (Cont.)
Installing the Hydraulic System Filters and Adding Oil (Cont.)
6. Verify that the vent plugs are removed before adding the oil.
7. Slowly pour the specied oil through the expansion reservoir until oil comes out of one of the vent plug holes.
8. Install the vent plug.
9. Torque the plug to 15 ft-lbs. (20 Nm).
10. Continue to add oil through the expansion reservoir until oil comes out of the remaining vent plug hole on the
other transmission.
11. Install the vent plug.
12. Torque the plug to 15 ft-lbs. (20 Nm).
13. Continue to add oil through the expansion reservoir until it reaches the FULL COLD line on the expansion
reservoir.
14. Proceed to Purging the Hydraulic System see “Purging Procedure,” chapter 7, page 7-8.
NOTE: Failure to perform the Purging Procedure after changing hydraulic lters and oil can result in
irreparable damage to the hydrostatic drive system.