Service Manual
3-50
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
MAINTENANCE
Sharpening the Blades
1. Use a le to sharpen the cutting edge at both ends of the blade (Figure 40).
NOTE: Maintain the original angle.
NOTE: The blade retains balance if you remove the same amount of material from both cutting edges.
2. Check balance of the blade by putting it on a blade balancer (Figure 41).
NOTE: If the blade stays in a horizontal position, the blade is balanced and ready to use.
3. If the blade is not balanced, le some metal off the end of the sail area only.
4. Repeat this procedure until the blade is balanced.
A
Figure 40
A B
Figure 41
A. Sharpen at the Original Angle
A. Blade
B. Balancer