Service Manual

5-16

Digital Edition - TITAN® HD Service Manual

January 2018

Table of Contents

CHASSIS

Seat

Removal

1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,

and remove the key. Engage the parking brake.

2. Disconnect the battery terminals.

3. Unlatch and raise the seat, disconnect the operator presence switch on the underside of the seat assembly.

4. Lower the seat back into the latched position.

5. Remove the bolt (A) and the seat pivot (B) from each side of the seat (Figure 15).

6. Unlatch the seat, then move the seat rearward, out of the way of the motion control box. Lift the seat off of the

machine.

Installation

1. Place the seat on top of the fuel tank retainer plate.

2. Move the seat forward, aligning the holes in the seat pan with the holes in the motion control box.

NOTE: Make sure the ange bushing is present in each side of the seat pan.

3. Install the bolt (A) and seat pivot (B) on each side of the seat (Figure 15).

4. Raise the seat and attach the wire harness to the operator presence switch.

5. Lift and lower the seat to verify proper function of the seat pivots and the seat latch.

6. Connect the battery terminals.

7. Verify proper function of the unit.

Figure 15