Service Manual

5-22
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
CHASSIS
Roll Over Protection System (ROPS)
Installation
1. Lift the ROPS assembly into position on the rear side of the mounting support.
2. Install the four mounting bolts (Figure 23).
NOTE: Orientation of the ROPS hardware is critical. Make sure that the bolts are orientated as shown
(Figure 22).
3. Torque the ROPS connecting hardware to 95 ± 5 ft-lbs. (122-135 Nm).
4. Install the right and left consoles. See “Console Installation,” chapter 5, page 5-10.
Figure 23