Service Manual

5-26
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
CHASSIS
Choke Control Assembly
Installation
1. Route the choke cable through the control panel assembly.
2. Thread the jam nut over the choke cable up to the control panel assembly (Figure 29).
3. Attach the choke cable assembly to the control panel with the jam nut.
4. Install the control panel assembly into the console.
5. Move the choke control lever to the open position (down).
6. Place the z-bend of the choke cable in the choke plate on the engine in the position previously noted.
7. Place the cable under the cable clamp.
8. Ensure that the choke control lever is pressed down fully and tighten the cable clamp.
9. Connect the battery terminals and verify proper function of the unit.
Figure 29