CONTENTS Page MODEL AND SERIAL NUMBER INSTALLATION POSITION MOWER UNDER MACHINE MOWER ADJUSTMENTS . Drive and Spindle Belts .
MODEL AND SERIAL NUMBER A Model and Serial Number identifies your Toto Sheet Horse attachment. These numbers should always be referred to when consulting with your dealer or factory concerning service, replacement parts, or questions you may have. If Model and Serial number plate Is removed during repair operations it should always be replaced. For your reference, record number from Model and Serial Number Plate on your attachment.
Remove wing nuts and washers securing footrest panel to machine. Remove footrest panel. Lift machine with suitable lifting device and slide mower under machine. Lower machine. Support both sides of deck with 2" x 4" wood blocks. Attach stabilizer bars to machine's frame top holes using 3/8 x 1 174 clevis pin and hairpin cotter on both sides (Fig. 4).
FIG. 8. Drive Belt Pensioning Spring Adjustment Level Mower 1. Using a low pressure tire gauge, adjust tire pressure in all four tires. Front Rear PSI 12 8 kg/em? 85 43 2. Side-to-side leveling of mower deck Is accomplished by lowering mower to mid cutting height and adjusting threaded eys bolts at front of deck {Fig. 8}, G T FIG. 9. Side-To-Sid Park mower on a level surface and position each side mower blade tips side-to-side.
settling, gauge wheels are ta be positions so they are approximately 1/4” to 3/8" above ground. IMPORTANT it is important that gauge wheels be adjusted each time height-of-cut Is changed, so that deck will follow contour of ground and does not scalp turf, 1. Remove hairpin cotter and clevis pin securing gauge wheel 1o cutting deck (Fig. 12). 2. Move gauge wheel up or down 1o required setting and reinstall clevis pin and cotter pin. 3. Reposition gauge wheels each lime height-of-cut setting Is changed.
MOWER REMOVAL 1. Loosen drive belt adjustment eye bolt and remove tension spring save parts {Fig. 8). 2. Work drive belt off center mower pulley and bat tensing swing arm idlers. 3. Push foot pedal forward and remove long spring from foot pedal lever arm (Fig. 5} save pairs. 4. Supper deck on both sides using 2 x 4" wood blocks, Reseals foot pedal and sower mower all the way down. 5. Remove stabilizer bar clevis pins and hairpin cotters from machine farms, 8. Remove two front chain bolts from mower. 7.
Pro Line Products TOR. THE TOR TOTAL COVERAGE GUARANTEE A One Year Limited Warranty (A Full Two—Year Warranty for Residential Use) What is Covered By This Express Warranty? The Tore Company promises to repair any TOR Pro Line product used for commercial, institutional, or rental purposes if defective in materials or workmanship for a period of one year from the date of purchase. The cost of parts and labor are included as well as transportation within & 15 mile radius of a TOR Praline Service Dealer.