Operator's Manual

12
4. Tighten the bagger mounting bracket to the side frame
(Fig. 11). See torque table.
5. Install the drive wheels.
6. Lower the machine onto the drive wheels.
Installing the Hydraulic Tank
Heat Shield on International
Machines
Note: This section is for international machines only.
1. Before installing the hydraulic tank heat shield, cut out
a section of the heat shield as shown in figure 15. This
will allow the heat shield to fit around the side bracket.
2
1
m–6119
1
Figure 15
1. Hydraulic tank heat shield 2. Removed section
2. Install the hydraulic tank heat shield with previously
remove hardware (Fig. 16).
8
3
1
5
m–6120
7
4
6
2
Figure 16
1. Hydraulic tank heat shield
2. Bagger mounting bracket
3. Short spacer
4. Long spacer
5. Bolt
6. Nut
7. Engine guard strap
8. Hydraulic tank
Installing the Bagger
1. Remove the four bolts in the skid plate (Fig. 18).
2. Remove the skid plate (Fig. 18). This will make it easier
to install the bagger belt.
3. Install the bagger onto the bagger mounting bracket
(Fig. 17).
4. Install clevis pins into the bagger and bagger mounting
bracket. Secure with hairpin cotter pins (Fig. 17).