Operator's Manual

13
2
4
1
3
m–6032
Figure 17
1. Bagger
2. Bagger mounting bracket
3. Hairpin cotter pin
4. Clevis pin
Installing the Tensioner Pulley
and Belt
1. Install the bagger belt onto the clutch drive pulley
(Fig. 20).
2. Route the bagger belt onto the bagger pulley
(Figures 18 and 20).
3. Remove the bolt, washer, spacer, and locknut from the
tensioner pulley arm (Fig. 18).
Note: Make sure the pulley is under the traction unit frame
when installing the tensioner pulley arm.
4. Install the tensioner pulley arm to the bagger with the
previously removed bolt, washer, spacer, and locknut
(Fig. 18).
5
6
4
1
3
m–6008
2
7
8
Figure 18
1. Bolt, 3/8 x 2–1/4 in.
2. Tensioner pulley and arm
3. Lock nut, 3/8 in.
4. Washer, 3/8 in.
5. Bagger
6. Skid plate
7. Bagger pulley
8. Spacer
5. Install the tensioner spring onto the bolt attached to the
bagger (Fig. 20).
Note: Make sure the bolt for the spring is set at 2 in.
(Fig. 19).