Operator's Manual

15
m–6047
4
6
4
5
5
5
2
1
3
7
8
Figure 21
1. Front floorpan
2. Footrest
3. Front frame
4. Bolt
5. Nut
6. Washer
7. Front caster wheel
8. Carrier frame
3. With the two holes towards the front, place the left and
right–hand weight brackets onto the front frame
(Fig. 22).
4. In the weight bracket rear holes, install the weights with
4 bolts (3/8 x 6–1/2 in.), 8 flat washers (3/8 in.), 4 lock
washers (3/8 in.), and 4 nuts (3/8 in.) (Fig. 22).
Note: Only the two inside weight brackets use the center
holes for installing the weights.
5. In the weight bracket center holes, install 2 bolts
(3/8 x 3/4 in.) into the weights (Fig. 22).
Note: After the weights are installed, pivot the caster
wheels near the weights to ensure clearance between the
wheels and the weights. Adjust the weights if needed.
9
m–6048
8
7
1
6
10
2
11
5
4
3
12
7
Figure 22
1. Weight—left
2. Weight—right
3. Weight bracket—left
4. Weight bracket—right
5. Center hole
6. Rear hole
7. Flat washer, 3/8 in.
8. Lock washer, 3/8 in.
9. Nut, 3/8 in.
10. Bolt, 3/8 in. x 6–1/2 in.
11. Bolt, 3/8 in. x 3/4 in.
12. Front frame
6. Install the two outside bolts that connect the front
floorpan to the carrier frame (Fig. 21).
7. Install only the top 2 bolts that hold the front floorpan
to the front frame (Fig. 21). Use existing hardware.
8. Using the bottom holes that hold the front floorpan,
install the support plate to the front of the machine with
2 new bolts (5/16 x 1 in.), 2 existing flat washers
(5/16 in.), and 2 existing flange nuts (5/16 in.) (Fig. 24).
Note: If the right–hand flange nut can not be reached, drill
an 11/32 in. diameter hole through the front floorpan using
the support plate as a template (Fig. 23).