Operator's Manual

8
m–6031
1
4
2
3
1
6
5
4
Figure 7
1. Bagger mounting
bracket—right–hand
shown
2. Bolt, 1/4 x 3/4 in.
3. Flange nut, 1/4 in.
4. Side frame
5. Engine guard strap
6. Existing 1/4 in. hole
6. Loosely, install the bagger mounting bracket to the
bottom rear bumper with 2 bolts (5/16 x 3/4 in.), 4 flat
washers (5/16 in.), and 2 flange nuts (5/16 in.) (Fig. 8).
1
1
4
2
4
3
m–6028
5
Figure 8
1. Bagger mounting bracket
2. Bolt, 5/16 x 3/4 in.
3. Flange nut, 5/16 in.
4. Bumper
5. Flat washers, 5/16 in.
7. Loosely, install the bagger mounting bracket to the
engine guard strap with 2 bolts (5/16 x 1 in.) and
2 flange nuts (5/16 in.) (Fig. 9).
8. Tighten all the bolts and nuts. Start with the 1/4 in. bolt,
then the 5/16 in. rear bumper bolts, and then the engine
guard strap bolts.