Operator's Manual

11
Installing the Bagger
1. Remove the four bolts in the skid plate (Fig. 16).
2. Remove the skid plate (Fig. 16). This will make it easier
to install the bagger belt.
3. Install the bagger onto the bagger mounting bracket
(Fig. 15).
4. Install clevis pins into the bagger and bagger mounting
bracket. Secure with hairpin cotter pins (Fig. 15).
2
4
1
3
m–6032
Figure 15
1. Bagger
2. Bagger mounting bracket
3. Hairpin cotter pin
4. Clevis pin
Installing the Tensioner Pulley
and Belt
1. Install the bagger belt onto the clutch drive pulley
(Fig. 18).
2. Route the bagger belt onto the bagger pulley
(Figures 16 and 18).
3. Remove the bolt, washer, spacer, and locknut from the
tensioner pulley arm (Fig. 16).
Note: Make sure the pulley is under the traction unit frame
when installing the tensioner pulley arm.
4. Install the tensioner pulley arm to the bagger with the
previously removed bolt, washer, spacer, and locknut
(Fig. 16).
5
6
4
1
3
m–6008
2
7
8
Figure 16
1. Bolt, 3/8 x 2–1/4 in.
2. Tensioner pulley and arm
3. Lock nut, 3/8 in.
4. Washer, 3/8 in.
5. Bagger
6. Skid plate
7. Bagger pulley
8. Spacer
5. Install the tensioner spring onto the bolt attached to the
bagger (Fig. 18).
Note: Make sure the bolt for the spring is set at 2 in.
(Fig. 17).
1
2
3
m–6092
Figure 17
1. Bolt for spring
2. Jam nut
3. 2 in.
6. Install the spring onto the tensioner pulley arm hook
(Fig. 18).