Addendum

 2004 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

48in and 52in Finishing Kit

Z400 and Z500 Twin Soft Bagger

Model No. 78511

Model No. 78512

Form No. 3352–708

Addendum

Important Use the following instructions for twin soft bagger, model 78507 with serial numbers 240999999 and lower.

The blower assembly will have a front latch guard as shown in Figure 1.

Note: Some bagger housings may already have the front latch guard trimmed.

Trimming the Front Latch

Guard

This will eliminate interference with the front caster wheel.

1. Remove the front latch guard from the front of the

blower housing as shown in Figure 1.

2. Put the mower deck in the lowest height–of–cut

position and verify if the latch guard hits the front

castor wheel. If it hits the caster wheel, remove more of

the latch guard.

m–7824

Figure 1

1. Front latch guard

2. Remove the shaded area

3. Blower assembly