Operator's Manual

11
m–6859
1
Figure 11
1. Drive wheel
7
Step
No parts needed for this step.
Removing the Roll Over
Protection System (ROPS)
1. Loosen the front handles securing the center roll bar
section to the right and left sections (Fig. 12).
1
2
m–6835
Figure 12
1. Front handle 2. Center roll bar section
2. Remove the hair pin cotters and pins securing the
center roll bar section to the right and left sections
(Fig. 13).
m–6893
1
2
Figure 13
1. Pin 2. Hair pin cotter
3. Loosen the center roll bar bolts allowing the roll bar to
be pivoted to the down position (Fig. 14).
1
2
Figure 14
1. Bolt 2. Flange nut
4. Remove the 2 bolts and 2 flange nuts securing the
center roll bar section to the right and left sections
(Fig. 14). Remove the center roll bar section.