Operator's Manual

12
5. Remove the following fasteners (Fig. 15) securing
each (right and left) roll bar section to the frame:
• Lock nut (3/8 inch) and curved washer. Do not
remove bolt from frame.
• Bolt (3/8 x 1 inch), curved washer and flange nut
(3/8 inch).
• Bolt (3/8 x 1 inch), curved washer and flange nut
(3/8 inch).
• Bolt (3/8 x 4-1/2 inches), curved washer and
flange nut (3/8 inch).
m–6854
1
2
2
3
Figure 15
1. Lock nut, 3/8 inch &
curved washer
2. Bolt, 3/8 x 1 inch, curved
washer & flange nut,
3/8 inch (2)
3. Bolt, 3/8 x 4–1/2 inches,
curved washer & flange
nut, 3/8 inch
6. Remove the roll bar section from frame (Fig. 15).
Repeat the procedure on the other roll bar section
8
Step
No parts needed for this step.
Removing the Bumper Guard
Danger
Mechanical or hydraulic jacks may fail to support
machine and cause a serious injury.
• Use jack stands when supporting machine.
• Do not use hydraulic jacks.
Remove the existing rear bumper guard (Fig. 16).
m–6794
1
2
3
Figure 16
1. Rear bumper guard
2. Bolt
3. Nut