Operator's Manual

14
m–6891
1
Figure 19
1. Center roll bar section
5. Raise the roll bar into the upright position and secure it
with the pins and hairpin cotter pins fastened to the
lanyards (Fig. 20).
m–6893
1
2
Figure 20
1. Pin 2. Hair pin cotter
6. Tighten the center roll bar bolts (1/2 x 3-1/4 inches) so
it rotates freely with some resistance (Fig. 21).
Note: No more than one thread should be exposed outside
the nut.
m–6891
2
1
Figure 21
1. Bolt 2. Flange nut
7. Torque all lower fasteners, attached to the machine
frame, to 30 ft–lb.
8. Tighten the front handles against the center roll bar
ends.
m–6835
1
Figure 22
1. Front handle