Operator's Manual

29
Checking and Adjusting the
Blower Latch
Adjust the blower latch when it is does not engage the
front peg correctly.
1. There must not be a gap between the mounting plate
the the blower assembly (Fig. 45). If there is a gap,
proceed to step 3 and shorten the latch.
1
3
2
m–626
8
Top view
4
Figure 45
1. Blower assembly
2. Blower front latch (Red)
3. Gap shown
4. Front peg
2. The blower latch must engage over the front peg
(Fig. 46). If it does not, proceed to step 3 and lengthen
the latch.
1
1
2
m–6721
Figure 46
1. Blower front latch (Red) 2. Front peg
3. To adjust the blower latch, loosen the jam nut.
(Fig. 47).
4
3
2
1
m–6720
Figure 47
1. Blower front latch (red)
2. Blower
3. Hex nut
4. Jam nut
4. To lengthen the latch turn the hex nut
counterclockwise to loosen the nut. (Fig. 47).
5. To shorten the latch turn the hex nut clockwise to
tighten the nut. (Fig. 47).
6. When the desired latch length is correct, tighten both
nuts. (Fig. 47).