Operator's Manual

31
3. Remove the blower adapter and tube from the blower
(Fig. 36).
4. Remove the five bolts that hold the blower liner to the
blower (Figures 50 and 51).
5. Pull the liner out of the blower (Fig. 50).
2
m–6244
3
1
4
5
Figure 50
1. Blower
2. Liner
3. Bolt
4. Washer
5. Nut
6. Remove any debris from the blower. Do not use your
hands to remove the debris.
7. Slide the new liner around the blower impeller.
8. Install 3 bolts into the rear of the blower and the liner
(Fig. 50).
9. Loosely install 2 bolts into the liner and the blower
(Fig. 51).
3
2
m–6243
1
4
Figure 51
1. Blower
2. Bolt
3. Nut
4. Impeller
10. Push the top 2 bolts down, toward the front of blower,
until the blower liner conforms to the inside of the
blower (Fig. 52). This will provide clearance between
the impeller and the liner.
11. Rotate the blower pulley to verify that the blower fan
does not hit the liner (Fig. 52). Adjust the liner if
necessary.
12. Tighten the 2 top bolts in the liner and the blower
(Fig. 52).
2
3
1
m–6220
Figure 52
1. Blower 2. Top bolt and nut