Operator's Manual

5
Setup
Important These instructions are for Z500 machines only.
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use the chart below to verify all parts have been shipped.
Important This kit and bagger will require significant time to install the first time. A right angle drill is recommended
for installation.
Step Description Qty. Use
1
No parts needed Removing the existing mower cover
2
No parts needed
Removing the anti-scalp roller and
bracket
3
Anti-scalp roller bracket
Tapping screw, 3/8 x 1 inch
1
1
Installing the anti-scalp roller and
bracket
4
Mounting plate
Bolt, 3/8 x 1-1/4 inch
Flange nuts, 3/8 inch
1
2
2
Installing the mounting plate
5
Pulley assembly 1 Installing the pulley assembly
6
No parts needed
Removing the drive wheels and bumper
guard
7
No parts needed
Removing the Roll Over Protection
System (ROPS)
8
No parts needed Removing the bumper guard
9
Left side bagger bracket
Right side bagger bracket
Bolt, 3/8 x 1–1/2 inch
Flange Nut, 3/8 inch
Curved washer, 3/8 inch
Spacer
1
1
6
6
6
4
Installing the side brackets to the
machine
10
Bagger mounting bracket
Bolt, 3/8 x 1 inch
Flange nut, 3/8 inch
Curved washer, 3/8 inch
1
6
6
6
Installing the bagger brackets