Operator's Manual

Figure 21
1. Hood plate
4. 3/4 inch (19 mm)
2. Upper tube 5. Edge of tube
3. Hood in the down position
7. Once the 3/4 inc h (19 mm) measurement has
been ac hiev ed, mark the upper tube on the
out side where the r ubber seal protr udes out.
T his is mark ed to ensure the cor rect position
for the upper tube when drilling the holes
and connecting the upper and lo w er tubes
( Figure 22 ).
Note: T he r ubber seal m ust protr ude out
from the bag g er hood.
Figure 22
1. Upper tube 3. Bagger hood
2. Rubber seal protruding out 4. Mark here against the
rubber seal
8. Install the lo w er tube into the upper tube
( Figure 23 ).
Figure 23
1. Lower tube 2. Upper tube
15