Operator's Manual

Figure 34

1. Idler pulley

4. Peg

2. Mower deck pulley 5. Belt

3. Spring

6. Blower pulley

6. Install the spring as sho wn in Figure 35 .

Figure 35

1. Spring loaded idler pulley 3. Long hook end

2. Short hook end

7. Pull bac k on the spring loaded idler pulley and

install the belt onto the spring loaded idler

pulley ( Figure 34 ).

Checking and Adjusting the

Blower Latch

Close the blo w er assembly to see if the latc hes are

adjusted cor rectly . Loosen or tighten the bolts so

the latc hes ﬁr mly hold the blo w er assembly ag ainst

the mo w er dec k , but can be released b y hand.

Figure 36

1. Latch 3. Blower assembly

2. Bolt

Greasing the Idler Arm

Grease the bag g er belt idler ar m ( Figure 37 ) ev er y

50 hours .

Figure 37

Inspecting the Bagger

Inspect the bag g er attac hment after the ﬁrst eight

hours of operation, and 100 hours thereafter .

1. Diseng ag e the PTO , mo v e the motion control

lev ers to the neutral loc k ed position, and set

the parking brak e .

2. Stop the engine , remo v e the k ey , and w ait for

all mo ving par ts to stop before lea ving the

operating position.