Operator's Manual

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
No parts required
–
Prepare the mower.
Bagger mounting bracket
1
Bagger side plate
2
Spacer 2
Bolt, (3/8 x 1-1/2 inches)
14
Bolt, (3/8 x 1 inch) (for Z593
mowers only)
2
Flange Nut, (3/8 inch)
14
2
Curved washer
14
Install the bagger mounting bracket
3
No parts required
–
Tighten all mounting bolts
Hood assembly
1
Bags
3
Clevis pin
2
4
Hairpin cotter pin
2
Install the hood assembly and bags.
5
Bagger belt (from Blower and Drive
Kit)
1
Route the bagger belt into the
blower assembly.
Blower assembly (from Blower and
Drive Kit)
1
6
Spring (from Blower and Drive Kit)
1
Install the blower assembly.
7
Upper tube
1
Size the upper tube for 60 inch
mowers with gas engines.
Upper tube
1
Lower tube
1
Bolt, (#10 x 3/4 inches)
3
Locknut, (#10)
3
8
Washer, (7/32 inch)
3
Install the discharge tubes.
9
Belt cover (from Blower and Drive
Kit)
Install the belt cover.
Caster weight
2
U-bolt
2
Nut, (1/2 inch)
4
Lock washer, (1/2 inch)
4
Plate
2
Top weight (for 60 inch mower
decks only)
2
10
Bolt, 1/2 x 2–1/2 inch- for top
weights
2
Install the weights.
11
No parts required
–
Adjust the parking brake.
12
No parts required
–
Check the tire pressure.
6