Service Manual

HY13-1521-M2/US Service Manual
General Information Series HB Hydrostatic Transmission
35
Parker Hannifin Corporation
Hydraulic Pump/Motor Division
Greeneville, Tennessee USA
Install top washer
Install thick (.261”) thrust
washer into swash block.
Apply Oil to top washer
Apply OEM recommended oil
to top of thrust washer.
Install charge pump
shaft and bearing
assembly into charge
pump cover.
Place charge pump cover
face down with the extended
shaft through hole in table.
Be careful as you insert shaft
assembly into charge pump
cover not to damage I.D. of
cover.
fter bearing
sure
ote: Flat washer not
ush shaft and bearing
f the
ote: Flat washer not
A
installation en
there is room for the
seal.
N
used after mid 2009 in
production.
P
assembly to the bottom o
cover.
N
required if present.