Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 79180

Printed in USA

FORM NO. 3323-210

INSTALLATION

INSTRUCTIONS

MODEL NO. 79180

HEADLIGHT KIT

for Lawn Tractor

Loose Parts

DESCRIPTION QTY. USE

Screw, 10-14 x 5/8” (16 mm) 2

Install headlights

Reflector & Lamp Assembly 1

nsta

dli

ts.

Headlight Wire Harness 1 Install wire harness.

Decal – Ignition/Lights 1

Illih

Decal – Ignition/Lights, International 1

Install switch.

Switch 1

Summary of content (4 pages)

PAGE 1
FORM NO. 3323-210 HEADLIGHT KIT for Lawn Tractor INSTALLATION INSTRUCTIONS MODEL NO. 79180 Loose Parts DESCRIPTION QTY. Screw, 10-14 x 5/8” (16 mm) 2 Reflector & Lamp Assembly 1 Headlight Wire Harness 1 Decal – Ignition/Lights 1 Decal – Ignition/Lights, International 1 Switch 1 Printed in USA USE Install headlights. headlights Install wire harness. I Install ll switch.
PAGE 2
Installation Instructions Install Headlights Install Wire Harness Locate the headlight reflector assembly over lens tabs inside the hood and secure with 10-14 x 5/8” (16 mm) screws (Fig. 1). Attach the headlight wire harness to the light receptacles starting with the longer leads to the right hand side. The terminals are the same so the wire connectors may be attached to either side of receptacle (Fig. 2).
PAGE 3
Installation Instructions Attach the clip, closest to the harness connector, to the bottom edge of the heat shield on the right hand side of the engine as shown (Fig. 3). Install Switch Drain the fuel tank; refer to operator’s manual. Plug the head light wire harness connector into the tractor wire harness connector near the starter (Fig. 3). 4 1 6 POTENTIAL HAZARD • In certain conditions gasoline is extremely flammable and highly explosive.
PAGE 4
Installation Instructions Remove the nut and washer securing the ignition switch to the dash and set aside (Fig. 5). Do not discard, they will be needed for assembly. Install the two tractor wire harness terminals to the headlight switch (Fig. 6). The terminals are the same size so the wires may be attached to either terminal. Locate the opening in the dash for the light switch and cut the decal out of hole (Fig. 5).