Setup Instructions

Printed in USA
FORM NO. 3316–885 Rev. A
SET-UP
INSTRUCTIONS
MODEL NO. 79203 – 4900001 & UP
MODEL NO. 99201 – 4900001 & UP
MODEL NO. 9861906 – T4N0001 & UP
VACUUM BAGGER
for 42” and 48” Mowers on Yard Tractor
This vac bagger contains parts and instructions for installation on 42” and 48” mowers for Yard Tractors.
Prepare the mower according to the instructions under Assembly; Mower Preparation, in the Vacuum Bagger
Operator’s Manual.
Install Mower Baffle
1. Remove the bolt(s) and nut(s) at the end of the
grass plate. Inside the mower near the back edge
of the discharge opening. Discard the hardware.
2. Select appropriate grass baffle (42” single hole
or 48” two holes) Install grass baffle tight
against grass plate with top edge up against
inside of mower.
3. Secure with new (5/16” x 1”) bolt(s) and (5/16”)
nut(s) (Fig. 1-42” or 2-48”).
4. Rotate blade and check for clearance with baffle.
If necessary adjust baffle so blade does not hit.
1
2
3
1492
4
Figure 1
1. Grass plate
2. 42” Baffle
3. Bolt
4. Nut
1493
2
4
1
3
Figure 2
1. Grass plate
2. 48” Baffle
3. Bolt
4. Nut