Installation Instructions

All Rights Reserved
Printed in the USA
1
W 2005 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Mulching Kit
38 inch Mowers for TimeCutterr Z Riding Mower
Model No. 79207
Form No. 3329–346 Rev B
Installation Instructions
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use the chart below to identify parts for assembly.
Description
Qty. Use
Decal 1 Installing the decal
Discharge cover
Bolt, 1/4 x 2–3/4 inch
Nut, 1/4 inch
1
2
2
Installing the discharge cover
Installing the Decal
Install the decal on left side of mower (Fig. 1).
1
2
Figure 1
1. Mulching decal 2. Left side of mower
Installing the Discharge Cover
1. Stop the engine and remove the ignition key.
2. Lift the grass deflector and slide the tabs on top of the
discharge cover under the grass deflector retaining rod.
Rotate the discharge cover down over the opening, and
onto the lower lip of the mower (Fig. 2).
3. Secure the discharge cover to the lower lip of the
mower with 2 bolts (1/4 x 2–3/4 inch) and 2 nuts
(1/4 inch) (Fig. 2).
Note: Do not over-tighten the nuts, this could distort the
cover and cause blade contact.
1
6
5
4
3
6
5
2
m–6469
Figure 2
1. Grass deflector
2. Tabs under retaining rod
3. Discharge cover
4. Lower lip of mower
5. Bolt, 1/4 x 2–3/4 inch
6. Nut, 1/4 inch
Removing the Discharge Cover
To convert to side discharge mode do the following
procedure.
1. Stop the engine and remove the ignition key.
2. Remove the 2 bolts (1/4 x 2–3/4 inch) and 2 nuts
(1/4 inch) that secure the discharge cover to the mower
(Fig. 2).