Addendum
All Rights Reserved
Printed in the USA
1
2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
38 and 42 Twin Bagger
TimeCutter
Z Attachment
Model No. 79214—230000001 and Up
Model No. 79215—230000001 and Up
Form No. 3329–822
Addendum
Important The following instructions are updates for
the Setup instructions in the Twin Bagger Manual.
Installing the Front Weight
The bagger adds a lot of weight to the rear of the
machine and may cause an unstable condition
which could result in a loss of control.
• Install the front weight.
Caution
Installing the front weight procedure can be done at
anytime during the setup.
1. Lift up the footrest and temporarily remove it from the
machine (Fig. 1).
m–6423
1
3
2
3
Figure 1
1. Footrest
2. Rod
3. Hole positions
2. Install the front weight to the bottom footrest frame
with 2 bolts (3/8 x 2–1/4 inch), 4 washers (3/8 inch) and
2 nuts (3/8 inch) (Figure 2).
Note: Make sure the weight is installed as shown in
Figure 2.
3. Install the footrest into the footrest frame while placing
the rods in the same hole positions (Fig. 1).
2
4
m–6686
5
4
3
1
Figure 2
1. Footrest frame
2. Bolt, 3/8 x 2–1/4 inch
3. Front weight
4. Washer, 3/8 inch
5. Nut, 3/8 inch
Important When you remove the twin bagger,
remember to remove the front weight.
Assembling the Bagger
Note: If the frame assembly is not installed to the bagger
cover, use the following instructions for installing it.
1. Install the frame assembly to the bagger cover with 2
locknuts (1/4 in.) (Fig. 3).
1
3
1849
2
Figure 3
1. Frame assembly
2. Bagger cover
3. Locknut, 1/4 in.