Operator's Manual

12
4. Open the collector; refer to Emptying the Quiet
Collector, page 11.
5. With the collector open, pull out the holding pin and
insert into the hole in the hinge (Fig. 20).
2
3
1
m-5961
Figure 20
1. Holding pin
2. Hole in hinge
3. Hinge
Changing the Draft Control
The draft control is located on the left side of collector.
There are three positions for the draft control: blow left,
blow right or collecting.
1. To blow right, move the draft control to the lowest
position (Fig. 21).
2. For collecting grass, move the draft control to the
middle position (Fig. 21).
3. To blow left, move the draft control to the highest
position (Fig. 21).
m–6545
1
4
3
2
Figure 21
1. Collector Draft control
2. Blow right position
3. Collect grass position
4. Blow left position
Clearing Obstructions From
the Collector
1. Empty the collector.
2. Disengage the mower PTO and set the parking brake.
3. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Remove the tube assembly from the collector.
5. Using a stick or similar object, carefully remove and
clear the obstruction from the mower, upper tube,
middle tube, or boot assembly.
6. After you remove the obstruction, install the complete
collector system and resume operation. Refer to
Installing the Discharge Tube on page 10.