Operator's Manual

5
Setup
Note: Determine the left and right sides of the machine
from the normal operating position.
Loose Parts
Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION QTY. USE
Quick hitch
Bolt, 3/8 x 1–1/4 in.
Locknut, 3/8 in.
Flat washer, 7/16 in.
1
2
2
4
Installing the quick hitch
Double pulley
Pulley mounting plate
Top plate
Locknut, 7/16 in.
Flange nut, 3/8 in.
Flat washer, 7/16 in.
Bolt, 3/8 x 3–1/2 in.
1
1
1
1
4
2
4
Installing the double pulley
Collector
Cotter pin
Knob
Clevis pin, 3/8 x 1–1/2 in.
Hairpin cotter pin
1
1
1
1
1
Installing the collector
Collector belt 1 Installing the collector belt
Upper tube
Straight tube
1
1
Installing the discharge tubes
Operator’s manual 1 Read before operation
Installing the Quiet Collector
Drive Kit
Note: Install the Collector Drive Kit before installing the
Quiet Collector.
Remove the Drawbar Hitch
1. Remove the snap ring from the pin and slide from the
drawbar and spacers. Remove the hitch from the tractor
(Fig. 2).
Note: Save the hitch and spacers for use when installing the
hitch.
2314
2
3
1
4
Figure 2
1. Snap ring
2. Pin
3. Drawbar
4. Spacer (2)