Installation Instructions

1
All Rights Reserved
Printed in the USA
 1991, revised 2002 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Weight Kit
Reelmaster

216-D, 2300–D, 2600–D and 2000–D
Part No. 83-9370
Form No. 3328–131
Installation Instructions
1. Disconnect negative and positive battery cables from
battery.
2. Remove 2 carriage screws and flange locknuts securing
battery hold-down to rear frame and remove hold-down
and battery. Discard fasteners.
3. Remove 3 capscrews, flat washers, and grommets
securing fuel tank to rear frame. Set fuel tank aside.
Retain flat washers and grommets for reinstallation.
4. Position weight on rear frame aligning mounting holes
with holes in frame. Threaded holes in center of weight
should be at the left front and right rear positions.
5. Use the charts below to determine size of mounting
fasteners required to mount weight(s), fuel tank and
battery to frame.
6. Using threaded holes in weight, secure it to frame with
2 flange head screws as shown in Figure 2.
7. If additional weights are to be mounted, proceed to
step 8, otherwise proceed to step 10.
Note: When stacking additional weights, make sure all the
unthreaded holes are aligned.
8. Turn top weight over and position on first weight so
threaded holes align with non threaded holes in center
of weights.
9. Using threaded holes in top weight, secure it to first
weight and frame with 2 capscrews and flat washers as
shown in Figure 2.
Reelmaster 2000–D
Drive
Type
Machines
Attachments
Weight Part No. and Qty. Required
Weight
Hardware
Tank Hardware Battery Hardware
Type Attachments
83-9390 94-3698 83-9370 Size Qty. Size Qty. Size Qty.
27” Reels 2 0 1 3/8 x 3” 2 3/8 x 4” 3 5/16 x 4” 2
2WD
27” Reels
w/Baskets or
32” Reels
3 2 1 3/8 x 4.5” 2 3/8 x 5.5” 3
5/16 x 5.5”
w/washer
2
27” Reels 1 0 1 3/8 x 2” 2 3/8 x 3” 3
5/16 x
2.75”
2
3WD
27” Reels
w/Baskets or
32” Reels
2 2 1 3/8 x 3.5” 2 3/8 x 4.5” 3
5/16 x 4.5”
w/washer
2
Reelmaster 216–D, 2300–D & 2600–D
Drive
Type
Machines
Attachments
Weight Part No. and Qty. Required
Weight
Hardware
Tank Hardware Battery Hardware
Type Attachments
83-9390 94-5974 83-9370 Size Qty. Size Qty. Size Qty.
2WD
27” Reels 1 0 1 3/8 x 2” 2 3/8 x 3” 3
5/16 x
2.75”
2
2WD
27” Reels
w/Baskets
1 1 1 3/8 x 4.5” 2 3/8 x 5.5” 3
5/16 x
2.75”
2
3WD 32” Reels 1 0 1 3/8 x 2” 2 3/8 x 3” 3
5/16 x
2.75”
2