PART NO. 84-0100 FORM NO. 3314-715 INSTALLATION INSTRUCTIONS . Since this instruction sheet covers only minimal amount of information necessary to allotment and operate your machine, wa suggest that vou keep this material with your Operator Manuals so that both may be referred ta for st ructions concerning safe operation and proper maintenance procedures.
REASSEMBLY Hub dirndl Pump bracket Se Sutton hose Figure s 43. Remove Toot pads frond erection pedant apply ALONG pads shaft and secure with ihe escapism and fe rew pedal using a sting Cabdriver: unfrock previously removed: 45. Surmountable a rod Bye (# 2411-38) and jar fit 44; Slide action pedals hart iio ame nine Application: $F 3220-3) to archfiend Of action linkage roo. Adjust rod ite # B60 10 action linkage arm. Slide traction linkage eye encl and position. as SRO in figure §.
REASSEMBLY 73. install protective sleeve onto he following hy 74. Using hydraulic ine coalition char forefather 2-wheal dratted ies; hydration: Hee 8225100, hydraulic line drive (Fig. 14) sor d-wheel dressmaking (Fig. 18), lus (# 82-5060 far model # 03600 ord 82-3870 for made! cater and install remaining hydraulic Ines hoses, Cable #03607), Secure sack sleeve to ine with w cable te: Hes ant mounting clamps. 340-58 Pg Fa 0-i8a Existing fine * 10-Yd. tank TRB ee i Riel drive ling pies” py KNB ad Hyd.
REASSEMBLY 2412-128 Tales on ase teal ding Existing ing 10 Hyd. tank 74-5220 §2:5180 ~N ma Hyd.
REASSEMBLY Seat prig rad Figure 17 §2. Connect wires To Capacitor and relay Mount Be clamp; capacitor: and relay tattooist winch bracken wil Cap sew and Tortoni, promiscuously removed: 83. beanstalk and seal plate with (2) cape craws; wash: ors and seal pivot sleeves Previously removed. Pivot sat now and install Lynch pin into seat each pin 84. Connect battery cables io battery. Connecting cables lo the wrong post could result in personal injury landlord damage tithe electrical system. £5.