Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 86041

FORM NO. 3322–656

Model

No. 86041

INSTALLATION

INSTRUCTIONS





 

  

Loose

Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Kicker

Carriage bolt 5/16–18 x 3/4” (19mm)

Spacer

Locknut 5/16” (7.9mm)

Install kickers

High–lift blade

Replace standard blades on mower

Baf

fle, left side

Baf

fle, right side

Bolt 5/16–18 x 1-1/4” (31.8mm)

Bellville washer

Locknut 5/16” (7.9mm)

Knob

Install Recycler



baf

fles

Decal 1

Install onto mower

Preparing

the Mower

1. Remove the mower from the tractor; refer to

Removing the Mower, in the Mower Operator’s

Manual.

2. Thoroughly clean the mower. All debris must be

removed to ensure that the baffles and kickers

will fit properly against the cutting chamber.

3. Tip the mower upside down and block up the

ends to ease installation of the Recycler



baffle.

IMPORTANT: There are bolts (washers and

locknuts) installed in some of the open holes

of the cutter deck for safety. Remove this

hardware if the hole is needed for installation

of the Recycler



kit. Save these fasteners and

reinstall them in the same open holes when

any portion of the Recycler



kit is removed.

Summary of content (4 pages)

PAGE 1
FORM NO. 3322–656  Model No. 86041 INSTALLATION INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Kicker 4 Carriage bolt 5/16–18 x 3/4” (19mm) 4 Spacer 4 Locknut 5/16” (7.9mm) 4 High–lift blade 3 Baffle, left side 1 Baffle, right side 1 Bolt 5/16–18 x 1-1/4” (31.8mm) 4 Bellville washer 4 Locknut 5/16” (7.9mm) 6 Knob 2 Decal 1 Preparing the Mower 1.
PAGE 2
Installation Installing the Kickers Installing the High-lift Blades Place spacers and kickers inside the mower, over the holes provided (Fig. 1). Remove any hardware installed in these holes and save for reinstallation if the kickers are removed. Secure the kickers with (4) 5/16–18 x 3/4” (19 mm) carriage bolts, (through from the top side of the mower) and (4) 5/16” locknuts (Fig. 1). . 1. Remove the standard blades (Fig. 2). 2.
PAGE 3
Installation Installing Recycler Decal Installing the Recycler Baffles 1. 1. Remove backing paper and apply decal to left side of mower (Fig. 4). Smooth from center to edges to remove air bubbles. Place the left side baffle inside the cutting chamber. Secure it with (2) 5/16” locknuts and (2) Bellville washers (Fig. 5). Note: 2.
PAGE 4
Installation Removing the Right Baffle for Side Discharge Cutting 1. Thoroughly clean the mower. 2. Remove the knobs and Bellville washers from the right side baffle (Fig. 5). Note: Only the right side baffle needs to be removed for side discharge mowing. Note: Save the hardware for use when reinstalling the baffle. 3. Lift the baffle and slide it out of the interlock with the left side baffle. 4.