Installation Instructions

Printed in USA

FORM NO. 3317–232

INSTALLATION

INSTRUCTIONS

PART NO. 92–7134

SNOWTHROWER DRIVE KIT

to change idlers and spring on snowthrower

This drive kit contains parts and instructions to modify the idler assembly of 42” snowthrowers on 260 series

Yard Tractors.

When installing a 42” snowthrower it is necessary to follow these instructions to replace the belt idlers and

tension spring on the idler assembly. Then follow the new, enclosed, Operator’s Manual; Installation procedure

and mount the snowthrower onto the tractor.

Loose Parts

Note: Use the chart below to verify all parts have been shipped.

DESCRIPTION QTY. USE

Idler Assembly 1 Replace idler assembly in snowthrower.

Operator’s Manual 1 Read and use for mounting instructions

Note: When installing new idler assembly (the one with the movable hook) to the tractor, use clevis pin and

hairpin cotter from loose parts bag or idler assembly with snowthrower (the one with the welded wire

form hook).

PAGE 1
FORM NO. 3317–232 SNOWTHROWER DRIVE KIT to change idlers and spring on snowthrower PART NO. 92–7134 INSTALLATION INSTRUCTIONS This drive kit contains parts and instructions to modify the idler assembly of 42” snowthrowers on 260 series Yard Tractors. When installing a 42” snowthrower it is necessary to follow these instructions to replace the belt idlers and tension spring on the idler assembly.
PAGE 2
Installation Instructions Transfer “V” Idler Pulley 1. Remove “V” idler pulley from idler assembly in snowthrower (the one with the welded wire form hook) (Fig. 1). Transfer the “V” idler pulley onto the kit idler assembly (the one with the movable hook) using same hardware (Fig. 1). Note: Idler hub extension must be facing slot and it rotate freely. 1623 2. Insert bolt into the center of the adjustment slot. 3. Torque idler bolt to.280 in.-lb. (31.6 Nm). Figure 2 1. Retainer 2.