Part No. 93-6437 FIRM NO. 93-6438 OPERATORS, SET-UP & PARTS MANUAL Note: The information given in this manual is meant to replace the corresponding information in the InJector-Pro™ System's Operator's, Parts and Set-up manuals. Note: If you are performing an initial set-up of the Indectar-Pro™ System skip Steps 1-6, 1. Remove Plastic Soupier from top of Injector Tank and discard. 2. Remove the 1/2" Close Hippie and Rinsing Nozzle from inside Injector Tank, 3.
When you stop spraying and pressure rinse your Injection Tank, 3 oz. of concentrated chemical remains in your injection Line. You can use this chemical for your last pass to eliminate waste. Use the formula below to figure the “Distance” of your last pass to leave untreated until after rinsing. Speed Distance Speed = Average Spray Speed In MPH. vol/min = The value reached in the "DETERMINING PUMP SETTING" section on Page the Indector-Pro™ System Operator's manual in 02/ min.
11, Turn Valve Handle back to the spray position. 12. Tum on Control Console depress the key labeled L momentarily. Enter 3.0 in this key. D 13, Re tum to the area left in last pass. Tum on Master Boom switch and spray 3 oz. of remaining chemical this distance. After “Chem 1 Voiume® display reaches ‘0" allow sprayer to spray an additional 18 sec. 14. Repeat Steps 1-13 to flush the Second Injection System if necessary. 15, After fishing injection Tank(s) attach Rinse Age to Hand Gun.