Installation Instructions

4
Part No.
93-6434
32104-95
93-6436
936435
Description
Cover Plate
HWHS 1/4-20 X 5/8"UNC, Self Tapping
U-clip
Cover Plate
Ref
1
2
3
4
Qty
1
4
4
1
COVER PLATES
1569
NOTE: The following procedure should be
followed when installing both Cover Plates.
1. Center Cover Plate over Adjust Hole in
Protection Casing and, using it as a template, mark
locations for holes to be drilled.
2. Check to be sure that the center of holes to be
drilled are NO MORE THAN 19mm (.75 in.) from
the edge of the Adjust Hole.
3. Drill two 7mm (9/32 in) holes at marked locations
through Protection Casing.
4. Install Cover Plate using two U-clips and hex
washer head self-tapping screws.
SET-UP INSTRUCTIONS