Installation Instructions

ManualsBrandsToro ManualsAttachmentsCE Update Kit - 2/3 Area Flat Beds

FORM NO. 3317-609

The TORO Company - 1995

TPS

PART NO. 93-9508

CE UPDATE KIT

WORKMAN 2/3 AREA FLATBED KIT

INSTALLATION

INSTRUCTIONS

SAFETY AND INSTRUCTION DECALS

THE FOLLOWING DECALS AND PARTS ARE TO BE INSTALLED ON THE

WORKMAN 2/3 AREA FLATBED KIT. USE THE LOCATION DESCRIPTION

LISTED BELOW TO DETERMINE THE CORRECT PLACEMENT FOR THE

DECALS ON THE PRODUCT. BEFORE INSTALLING DECALS, REMOVE OR

THOROUGHLY CLEAN THE ENGLISH DECAL, AND APPLY THE

APPROPRIATE TRANSLATED LANGUAGE VERSION IN ITS PLACE (OR

OVER IT).

SHOULD ANY OF THESE DECALS OR GUARDS BECOME DAMAGED OR

ILLEGIBLE, REPLACE THEM IMMEDIATELY. EACH PART NUMBER IS

LISTED BELOW, AND ALSO ON EACH DECAL. REPLACEMENTS MAY BE

ORDERED THROUGH YOUR AUTHORIZED TORO DISTRIBUTOR.

DESCRIPTION LOCATION

ENGLISH

PART NO.

EUROPEAN

PART NO.

QTY.

Plate

Lift

Bed - 93-9520 4

Decal

Lift Point

Lift Plate - 93-9084 4

Screw

Cap Hex. Hd.

Lift Plate - 323-6 4

Decal

40 KG

Lift Plate - 93-9526 4

Nut

Lock, Flange

Lift Plate - 32128-43 4

Decal

Warning

Underside of Bed 92-1312 93-9899 2

Decal

No Riders

Front Panel

Top

92-5955 93-9867 1

Decal

Caution

Side Panels 92-1319 93-9868 2

INSERT DECAL LOCATION SHEET AND CERTIFICATE OF COMPLIANCE

SHEET INTO OPERATOR'S MANUAL FOR OWNER'S REFERENCE.

Summary of content (2 pages)

PAGE 1
FORM NO. 3317-609 PART NO. 93-9508 INSTALLATION INSTRUCTIONS CE UPDATE KIT WORKMAN 2/3 AREA FLATBED KIT SAFETY AND INSTRUCTION DECALS THE FOLLOWING DECALS AND PARTS ARE TO BE INSTALLED ON THE WORKMAN 2/3 AREA FLATBED KIT. USE THE LOCATION DESCRIPTION LISTED BELOW TO DETERMINE THE CORRECT PLACEMENT FOR THE DECALS ON THE PRODUCT. BEFORE INSTALLING DECALS, REMOVE OR THOROUGHLY CLEAN THE ENGLISH DECAL, AND APPLY THE APPROPRIATE TRANSLATED LANGUAGE VERSION IN ITS PLACE (OR OVER IT).
PAGE 2
MOUNT LIFT PLATES Note: Mounting holes may already be in bed. 3. Affix a lift point decal, Part No. 93-9084 and a weight decal, Part No. 93-9526 onto each lift plate, positioning decals as shown in figure 2. 1. Using dimensions shown in figure 1, locate, mark and drill (2) .406" dia. holes in each side of bed. 1 .406" Dia. (4) 2 1.42" 8.00" Figure 1 2. Mount (4) lift plates to bed with (4) 3/8-16 X 1" lg. capscrews and locknuts. Position plates as shown in figure 2. 2 3 Figure 2 1. Lift plate 2.