Installation Instructions

FORM NO. 3319–296

PART NO. 94–1592

INSTALLATION

INSTRUCTIONS

 

   

Loose Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Spring

Chain

Carriage bolt 5/16–18 x 1-1/4” (32 mm)

Washer 5/16” (19 mm)

Install between footrest and mower

Attach Chain to Tractor

1. Shut off engine and and wait for all moving parts

to stop. Remove spark plug wire(s).

POTENTIAL HAZARD

• If you leave the wire on the spark plug,

someone could start the engine.

WHAT CAN HAPPEN

• Accidental starting of engine could

seriously injure you or other bystanders.

HOW TO AVOID THE HAZARD

• Pull wire off spark plug before you do any

maintenance. Also push wire aside so it

does not accidentally contact spark plug.

PAGE 1
FORM NO. 3319–296 PART NO. 94–1592 INSTALLATION INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Spring 1 Chain 1 Carriage bolt 5/16–18 x 1-1/4” (32 mm) 1 Washer 5/16” (19 mm) 3 USE Install between footrest and mower Attach Chain to Tractor 1. Shut off engine and and wait for all moving parts to stop. Remove spark plug wire(s).
PAGE 2
Installation 2. Remove existing hardware and clip from outer right rear footrest support rod (Fig. 1). 3. Replace existing carriage bolt with longer 5/16 x 1-1/4” (32 mm) carriage bolt from kit (Fig. 1). 4. 5. Place retaining clip and two 5/16” (19 mm) washers onto carriage bolt, then mounting link of chain. Secure with third washer and existing nut (Fig. 1). Hook spring around wheel shaft at rear of mower (Fig. 1).